Check the printer cover reed switch

WHAT YOU NEED 

Tools:Allen Key Set

Safety Equipment:Standard Personal Protective Equipment

  1. With the printer cover closed, visually inspect the reed switch for any signs of damage or misalignment.

  2. If misaligned, do the following:

    1. Slightly loosen the screws that hold the printer guard to the printer backing plate.
    2. Twist the printer guard to realign the reed switch on the printer cover with the magnet.
    3. Re-tighten the screws that hold the printer guard to the printer backing plate.
  3. Make sure both print modules are enabled in the plate marking control panel.
  4. Make sure the CONTROL light is on.
  5. Lift the printer cover and make sure the status of both print modules reads "Case open".
  6. Close the printer cover and make sure the status of both print modules reads "Init" followed by "Standby". The status indicators of all print heads should now be green.